Geemarc Telephone Petite Trac User Manual

PETITE TRAC  
User guide  
 
SETTING UP  
CLOCK TIME SETTING  
The correct time should be set as follows:  
- Press and hold down Time button.  
- Whilst holding down the Time button, press Hour and then Minute  
buttons as necessary to display the correct time.  
Note: that the clock is a 12 hour clock; in the case of PM, an indicator will  
show to the top left of the clock display.  
RINGER SETTING  
A switch (Ringer) located on the rear of the base unit allows the ringer to  
be switched On or Off.  
If you do not wish the telephone to ring, set the switch to the Off position. The  
ringer lamp will still flash on receipt of a call.  
Outgoing calls can still be made when the switch is set to the Off position.  
DIMMER SETTING  
A switch (Dimmer) located on the left side of the base unit allows to adjust  
(Hi or Lo) the brightness of the display.  
 
USING THE TELEPHONE  
ANSWERING INCOMING CALLS  
When an incoming call is received, the telephone rings (if the Ringer  
switch is On) and/or the lamp flashes.  
To answer the call lift the handset and speak.  
MAKING A CALL  
Lift the handset, await the dial tone and dial required number.  
On completion of the call, carefully replace the handset in the cradle.  
LAST NUMBER REDIAL  
If the telephone number you have called is engaged or you wish to repeat the  
call before making further calls, lift the handset, await dialling tone and press  
the REDIAL button.  
The previously dialled number will be automatically redialled.  
RECALL, * & # BUTTONS  
These are used with the new services provided on digital exchanges. For  
details please contact your network operator.  
 
USING THE TELEPHONE  
MUTE BUTTON  
- If you wish to speak privately to someone else in the room – without your  
caller overhearing – press and hold the MUTE button.  
Your caller may still be heard during the MUTE operation.  
- To resume normal conversation , release the MUTE button.  
For product support and help visit our website at  
telephone 01707 384438  
or fax 01707 372529  
 
RADIOALARM CLOCK OPERATE  
The radio has 2 wavebands: Medium Wave (AM) and VHF (FM). A built in  
aerial is incorporated for Medium Wave reception. For VHF reception, the  
thin lead should be unwound and fully extended.Adjust the position of the  
lead for best results.  
On this unit the Volume control and Tuning control are located at the right  
hand side.  
The buttons for operating radio (AM/FM and Radio/Off/Auto) are located at  
the left hand side.  
SET THE RADIO  
- Set the radio Radio / Off / Auto switch to the Radio position, the AM /  
FM switch to the desired waveband and adjust the Tuning control to your  
choice of programme.Adjust the Volume control as required.  
- To switch the radio off, slide the Radio / Off / Auto switch to the Off  
position.  
SET THE ALARM TIME  
Press and hold down the Alarm Set button and set the alarm time by using  
the Hour and Minute buttons to set the clock.  
 
RADIOALARM CLOCK OPERATE  
WAKE UP TO MUSIC  
Set the alarm time and select your desired radio station, adjust the volume  
control to your preferred listening level and proceed as follows:  
- Slide the Radio / Off / Auto switch to the Auto position (if the radio was  
playing this action will switch it off).  
The alarm indicator at the bottom left hand of the clock display will  
illuminate.  
- To switch the radio off after waking up press the Sleep button followed by  
the Snooze button.  
The radio will turn on again at the same time the next day.  
- To switch the radio off permanently after waking up set the Radio / Off /  
Auto switch to the Off position.  
WAKE TO BUZZER  
- Follow the instructions as per Wake up to music but set the volume switch  
to Off.  
The alarm indicator at the bottom left of the clock display will illuminate.  
- To switch the buzzer off after waking up, press the Sleep button followed  
by the Snooze button.  
The buzzer will turn on again at the same time the next day.  
 
RADIOALARM CLOCK OPERATE  
SNOOZE OPERATION  
When the radio is switched on by the alarm, pressing the Snooze button  
will silence the radio for approximately 9 minutes. The alarm will then  
switch the radio or buzzer on again.  
SLEEP TO MUSIC  
The radio can be set to play and switch off automatically for a length of  
between 1 minute and 1 hour 59 minutes.  
- The radio Volume have to be switched on.  
- Set the Radio / Off / Auto switch to the Off position. (Note that the  
alarm, if set will not operate in this condition).  
- Press and hold down the Sleep button.  
For a length of time over 59 minutes press the Hour button and release.  
- Still holding Sleep button press Min button, the display will indicate 1 hour  
59 minutes and will start to count down.  
When the chosen sleep time is indicated release the buttons. The radio will  
operate for the chosen time and then switch off.  
- To switch the radio off before the chosen 'sleep time' is indicated, press the  
Snooze button.  
telephone01707 384438  
or fax 01707 372529  
 
RADIOALARM CLOCK OPERATE  
COMBINATION OF SLEEP AND WAKE TO MUSIC OPERATION  
The radio can be adjusted to automatically switch off in the 'sleep to music'  
operation and to switch on automatically again at the preset alarm time.  
- Set the radio as per WAKE UP TO MUSIC operation.  
- Slide the Radio / Off / Auto switch to the Auto position.  
- Press and hold down the Sleep button.  
For a length of time over 59 minutes press the Hour button and release.  
- Still holding Sleep button press Min button, the display will indicate 1 hour  
59 minutes and will start to count down. When the chosen sleep time is  
indicated release the buttons.  
Note : if the Radio / Off / Auto was previously switched Radio, ensure  
that it is switched to the AUTO position after setting the sleep time.  
- The radio will continue to play before switching off by itself and will switch  
on again at the preset alarm time.  
- To switch the radio off before the chosen ‘sleep timehas elapsed, press  
the Snooze button.  
AUTO RADIO MUTING  
If there is an incoming telephone call while the radio is playing, the radio  
will be muted when the handset is lifted.  
 
GUARANTEE  
From the moment your Geemarc product is purchased, Geemarc guarantee it  
for the period of one year. During this time, all repairs or replacements (at our  
option) are free of charge.Should you experience a problem then contact our  
cover accidents, negligence or breakages to any parts. The product must not  
be tampered with or taken apart by anyone who is not an authorised Geemarc  
representative.The Geemarc guarantee in no way limits your legal rights.  
IMPORTANT: YOUR RECEIPT IS PART OF YOUR GUARANTEE AND  
MUST BE RETAINED AND PRODUCED IN THE EVENT OF A  
WARRANTY CLAIM  
Please note:The guarantee applies to the United Kingdom only.  
Declaration : Hereby Geemarc Telecom SAdeclares that this product is in  
compliance with the essential requirements and other relevant provisions of  
the Radio and Telecommunications Terminal Equipment Directive 1999/5/  
EEC and in particular article 3 section 1a, 1b and section 3. The telephone  
does not operate if the line current is lower than 18 mA.  
Electrical connection : The apparatus is designed to operate from a 230V  
50Hz supply only. (Classified as «hazardous voltage» according to EN60950  
standard).The apparatus does not incorporate an integral power on/off switch.  
To disconnect the power, either switch off supply at the mains power socket or  
unplug theAC adaptor. When installing the apparatus, ensure that the mains  
power socket is readily accessible.  
Telephone connection : Voltages present on the telecommunication network  
are classified TNV-3 (Telecommunication Network Voltage) according to the  
EN60950 standard.  
The alarm clock of this equipment may malfunction when there is radio  
interference appeared on the enclosure or power line or signal line. The unit will  
revert to normal operation when the interference stop.  
Under the environment with electrostatic discharge, the alarm clock of this  
equipment may malfunction and require user reset.  
UGPTRAC ED02  
 

Crown Audio Car Amplifier CDI1000 User Manual
Cub Cadet Oven 1450 User Manual
Delta Electronics Power Supply 1050 User Manual
Desa Tech Indoor Fireplace CGD3924PT User Manual
Digicom Network Card 8E4088 User Manual
Edelbrock Automobile Parts 17934 User Manual
Electro Voice Speaker System DH2T 16 User Manual
Fujitsu All in One Printer 6600 Pro User Manual
Gaggenau SONAR CE 490 612 User Manual
Global Machinery Company Biscuit Joiner BJ600 User Manual