Coleman Tent 2000001591STITCHLINE User Manual

TM  
HOOLIGAN 4  
MODEL 2000001591  
7. Assemble thin, black, shock-corded Vent Pole.  
Before you begin  
8. Insert Vent Pole through  
sleeve at back of tent.  
(Fig. 5)  
9. Insert metal tip into  
grommet. Go to opposite  
end of Vent Pole and  
gradually apply pressure  
to pole forming an arch  
then insert metal  
Sleeve  
Vent Pole  
Read all instructions before set up.  
• Select a level site clear of rocks, branches, and other hard or  
sharp objects, to install your tent.  
WARNING: Keep clear of overhead power lines.  
• Do not set up your tent under trees because of potential  
lightning strikes or falling tree limbs in inclement weather.  
• Secure with all stakes and guylines provided to prevent  
property damage or personal injury.  
• For best results in windy conditions, position narrow end of  
tent into the wind.  
• Enlist the help of at least one other person to assist you when  
it is time to assemble the tent.  
Back of Tent  
Fig. 5  
tip into grommet.  
(Fig. 6 & 6A)  
Fig. 6  
6A  
Pole Descriptions  
To Attach Rainfly  
Pole  
Pole  
Pole  
1. Drape Rainfly over tent. Make sure seams on Rainfly are  
facing down and centered over poles and the vestibule is  
over to door of the tent. (Fig. 7)  
Description  
Qty. Dia.  
Repair Kit Replacement Kit  
Main Pole, black  
Vestibule Pole, grey  
2
1
8.5mm 501000541  
8.5mm 501000541  
501000547  
501000547  
NOTE: Hook and loop fasteners, located on seams of under-  
side of rainfly, should be centered over black poles.  
Vent Pole, black, short  
with pre-bent ferrules  
1
6.3mm 501000638  
501000638  
Rainfly  
To Set Up Tent  
Vestibule  
over Door  
1. Unfold tent and spread out on a clean, level surface with the  
door facing perpendicular to the wind direction. Unzip door.  
2. Assemble Main Poles by interlocking the black, shock-cord-  
ed, sections.  
3. Insert Main Poles through sleeves in top of tent. (Fig. 1)  
Front  
of Tent  
Fig. 1  
Back of Tent  
Fig. 7  
Door  
2. Fold Rainfly at front of tent back as shown in Fig. 8.  
3. Assemble Vestibule Pole by interlocking the grey, shock-  
corded, sections.  
Main  
Pole  
4. Insert one end of grey Vestibule Pole into pin on metal loop  
located at either side of tent. (Fig. 8 & 8A)  
Main  
Pole  
Sleeve  
Sleeve  
5. Go to opposite end of Vestibule Pole and gradually apply  
pressure to pole forming an arch. Insert pin into the pole end  
(Fig. 8 & 8A).  
4. Insert one end of black Main Pole into pin on metal loop  
located at either end of tent. (Fig. 2)  
5. Go to opposite end of Main Pole and gradually apply pressure  
to pole forming an arch. Insert pin into  
Grey Vestibule Pole  
Hook & Loop  
Fasteners  
the pole end (Fig. 2 & 3). Repeat for the  
remaining Main Pole.  
Main  
Pole  
Metal  
Loop  
& Pin  
Fig. 2  
Door  
Front of  
Tent  
Stake  
Stake  
Fig. 3  
Fig. 8  
6. Stretch out corners and sides of  
tent. Drive in stakes at an angle  
through the metal loops to help  
anchor the corners & sides of the  
8A  
Fig. 4  
tent. (Fig. 3 & 4)  
(continued on other side)  
 

Conair Electric Shaver HGL1 User Manual
Cooper Lighting Landscape Lighting OVY15SWW2D4 User Manual
Cornelius Refrigerator CH 250 User Manual
Craftsman Lawn Mower 91738721 User Manual
Craftsman Lawn Mower 91738862 User Manual
Craftsman Log Splitter 247287751 User Manual
Cuisinart Coffeemaker DGB 600BCC User Manual
Delta Electronics Power Supply SILM8030 User Manual
Garland Range U48 2G36LL User Manual
GE Double Oven JBP82 User Manual