TRENDnet Router TRENDnet User Manual

Quick Installation Guide  
TEW-435BRM  
 
1. Before You Start  
Package Content  
TEW-435BRM  
Quick Installation Guide  
User's Guide CD-ROM  
1 x 2dBi Detachable Antenna  
1 x RJ-45 Ethernet Cable (Yellow)  
1 x RJ-11 Telephone Cable (Gray)  
Mounting Stand  
Power Adapter  
Installation Requirements  
A working DSL Internet Connection  
A computer with a wired or wireless network adapter properly installed.  
Web Browser: Internet Explorer (5.0 or higher) or Netscape Navigator  
(4.7 or higher)  
Application  
54Mbps 802.11g ADSL  
Modem Router  
(TEW-435BRM)  
Internet  
ADSL Account  
Ready Line  
Phone Jack  
Workstation with  
PCI Adapter  
(TE100-PCIWN)  
Notebook with  
Wireless PC Card  
(TEW-421PC)  
Workstation with  
Wireless PCI Adapter  
(TEW-423PI)  
54Mbps  
10/100Mbps  
1
 
English  
Collect Internet Service Provider (ISP) Information  
During the installation of your Wireless ADSL Modem Router, the Setup Wizard  
will automatically detect your ISP connection type. If the router cannot detect  
your ISP connection type, you can manually specify the connection type.  
Please verify your DSL Internet broadband connection type with your ISP and  
ensure you have all the information for one of the following connection types:  
A. Dynamic IP connection  
ADSL Modem parameters (VPI or VCI), if it cannot be detected automatically.  
ISP may require you to use a particular Hostname or Domain name.  
B. Static or Fixed IP connection  
Internet IP Address:_____. _____._____._____ (eg. 215.24.24.129)  
Subnet Mask: _____. _____._____._____  
Gateway IP Address: ____. _____._____._____  
Primary DNS:_____. _____._____._____  
Secondary:_____. _____._____._____  
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.  
C. PPPoE or PPPoA Dynamic IP connection  
Login User Name: _________  
Password: ________________  
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.  
D. IPoA Static or Fixed (IP over ATM) connection  
Internet IP Address:_____. _____._____._____ (eg. 215.24.24.129)  
Subnet Mask: _____. _____._____._____  
Gateway IP Address: ____. _____._____._____  
Primary DNS:_____. _____._____._____  
Secondary:_____. _____._____._____.  
ADSL Modem Parameters (VPI or VCI), if it cannot be detected automatically.  
2
 
English  
2. Hardware Installation  
1. Attach the mounting stand to the  
side of the unit.  
2. Connect one end of the yellow RJ-  
45 cable to one of the  
TEW-435BRM's LAN ports.  
Connect the other end of cable to  
the computer's Ethernet port. Then  
connect the 2dBi detachable  
antenna.  
3. Connect one end of the gray RJ-11  
cable to the TEW-435BRM's ADSL  
port. Connect the other end of the  
cable to the phone jack.  
4. Connect the AC Power Adapter to  
the TEW-435BRM and then to a  
power outlet.  
5. Verify that the following panel lights  
are on: Power, LAN, and WLAN.  
3
 
English  
3. Configure the Modem  
Note: It is recommended that you configure the Modem from a wired computer.  
1. Open your web browser, type  
Address bar, and press Enter.  
2. Enter User name and Password,  
and then click OK. By default,  
User name: admin  
Password: password  
3. Click Setup Wizard.  
4
 
English  
4. Click Next.  
Note: In the example, the DSL connection is PPPoE.  
5. Select Auto-detect, and then click  
Next.  
6. Wait for the Auto Detection process  
to complete.  
5
 
English  
Note: If the Setup Wizard could not automatically detect your Internet  
connection, select Manual Selection and input the information using the  
information provided by your ISP.  
7. Configure the settings based on  
information provided by your ISP.  
Then click Next.  
Note: For other connection methods, follow the on screen instructions after the  
Auto Detection.  
8. Check Test Internet Connection,  
and then click Finish.  
9. Verify that the ADSL LED is lit and  
then click Close.  
Your installation is now complete.  
For detailed information regarding the TEW-435BRM's configuration and  
advanced settings, please refer to the Troubleshooting section, User's Guide  
6
 
English  
Troubleshooting  
message says “The page cannot be displayed.” How can I get into the  
TEW-435BRM's web configuration page?  
A1: First, check your hardware settings again by following the instructions in  
Section 2. Second, make sure the LAN and WLAN lights are lit. Third, make sure  
your TCP/IP settings are set to Obtain an IP address automatically (see the  
steps below).  
1. Go into the Control Panel and double-  
click the Network Connections icon,  
right-click the Local Area Connection  
icon and then click Properties.  
2. Click Internet Protocol (TCP/IP) and  
then click Properties. Then click on  
Obtain an IP address automatically.  
Fourth, press on the factory reset button for 15 seconds.  
Q2: The Modem does not auto-detect my DSL connection. What should I do?  
A2: First, verify that your DSL account is activated. Second, make sure all the  
cables are properly connected (see Section 2). Third, in Section 3, select manual  
selection in the Setup Wizard and configure the Modem based on information  
provided by your ISP.  
7
 
Q3: All the settings are correct, but I can not make a wireless connection to the  
Modem. What should I do?  
A3: First, double check that the WLAN light on the Modem is lit. Second, power  
cycle the Modem. Unplug the power to the Modem. Wait 15 seconds, then plug  
the power back in. Third, log into your Modem (see Section 3). Click on Wireless  
and make sure Enable Access Point is checked. Fourth, contact the  
manufacturer of your wireless network adapter. Make sure the wireless network  
adapter is configured with the proper SSID. The preset SSID of the Access Point  
is default.  
If you still encounter problems or have any questions regarding the TEW-435BRM,  
please contact TRENDnet's Technical Support Department.  
Certifications  
This equipment has been tested and found to comply with FCC and CE Rules.  
Operation is subject to the following two conditions:  
(1) This device may not cause harmful interference.  
(2) This device must accept any interference received.  
Including interference that may cause undesired operation.  
Waste electrical and electronic products must not  
be disposed of with household waste. Please  
recycle where facilities exist. Check with you  
LocalAuthority orRetailer forrecycling advice.  
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV  
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS  
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO  
OPERATE THE EQUIPMENT.  
8
 
TRENDnet Technical Support  
.
US Canada  
Toll Free Telephone: 1(866) 845-3673  
24/7 Tech Support  
.
.
.
.
.
Europe (Germany France Italy Spain Switzerland UK)  
Toll Free Telephone: +00800 60 76 76 67  
English/Espanol - 24/7  
Francais/Deutsch - 11am-8pm, Monday - Friday MET  
Worldwide  
Telephone: +(31) (0) 20 504 05 35  
English/Espanol - 24/7  
Francais/Deutsch - 11am-8pm, Monday - Friday MET  
Product Warranty Registration  
Please take a moment to register your product online.  
3135 Kashiwa Street  
Torrance, CA 90505  
USA  
 
Copyright ©2006. All Rights Reserved. TRENDnet.  

TDK Network Card HHM Series HHM1713E2 User Manual
Tekkeon MP3 Docking Station ND2000 User Manual
Tempo Home Gym 910B 920B User Manual
Tiffen Camcorder Accessories Neutral Density Filters User Manual
Toastess Toaster TO90N User Manual
Toro Lawn Mower 14AK81RK744 User Manual
Toshiba Cash Register FS 160 SERIES User Manual
Toshiba VCR W 515 User Manual
TROY Group Computer Drive 50 70407 002A User Manual
Viking Double Oven VDSC560 6GQSS User Manual